C6 Corvette Center Louver for your Hood, Heat Extractor, Reduce your underhood temps

Designed specifically for the C6 corvette hood lines, low pressure zones behind the radiator, and above high temperature header zones.
Includes center vent only
GT2 Fender vents shown in pic are not included in this kit.
GT2 Fender vents can be added in options below for money saving kit!
Dimensions:
Center
18.3" Height
16.3" Front Width
18.4" Rear Width

 

• Currently used on multiple winning SCCA/NASA ST2, T1 and GT2 race cars.
  Optimized louver design to maximize extraction flow velocities within a vehicle in motion
  Reduces under hood pressure delta to reduce front end lift and increase net vehicle downforce.
  Significantly reduces under hood temperatures by extracting heat and allowing fresh cold air to enter the engine bay.
  Maximize life of engine accessories by reducing overall operating temperature.
  Increases dense, cold air flow through radiator to promote lower coolant temperatures.
  Louver backbone design maintains hood structural rigidity.
  Contoured to fit your specific hood curve.
  Installs easily with supplied templates.
  Included in kit: Templates for cutting, rivets, washers, installation instructions, and necessary spacers for a factory quality installation.
  Powder coated Satin Black for clean appearance and durability.