The Lingenfelter C6 ZR1 LS9 supercharger snout or supercharger front cover provides reduced pressure drop and increased horsepower on stock and higher pulley ratio applications.
The Lingenfelter front supercharger cover casting was designed to provide a more direct path for the airflow from the throttle body to the supercharger. This provides reduced inlet restriction resulting in increased boost and reduced supercharger work. This results in reduced supercharger parasitic losses and reduced supercharger outlet temperatures.
- Lingenfelter has seen chassis dyno tests results of 30 horsepower rear wheel gain over the stock snout on a ZR1 in testing with our upper pulley kit already installed.
- The cover casting is based on the inlet design first used on the Lingenfelter modified 2009 ZR1 that has run 9.813 seconds at 145.74 mph in the quarter mile.
- Drag strip, chassis dynamometer and engine dynamometer proven design.
- Cast from 356T6 aluminum, 100% leak checked using OEM decay type leak checking process
- Casting has also been designed with extra material in order to allow for the use of larger throttle bodies including 100 mm throttles. Inlet porting and/or machining are required for proper 100 mm throttle body fitment.
- For increased durability under higher supercharger loads the cover features a stainless steel 10 bolt hub that allows pulleys to be quickly changed on the car.
Because the throttle body alignment changes with the LPE supercharger cover it will requires the use of a new air intake system. LPE has designed an air intake system with revised duct work to connect to the new throttle body location along with a large surface area air filter with a sealed shroud to keep hot engine compartment air out of the inlet.
10 Bolt Supercharger Pulley Choices stock balancer 2.60 inch - 19% OD - 18,300 RPM supercharger speed* 2.35 inch - 32% OD - 20,300 RPM supercharger speed*
10 Bolt Supercharger Pulley Choices overdrive balancer 2.60 inch - 36% OD - 20,800 RPM supercharger speed* 2.35 inch - 50% OD - 23,000 RPM supercharger speed*
*Measured at 6,500 RPM engine speed / Stock supercharger speed 15,400 RPM
Supercharger Pulley
Belt Description
Part number/ belt / idler
2.60 diameter
Stock belt
100 mm idler L250130309
2.35 diameter
82.5 inch 11 rib belt
76 mm idler L25012030
With Lingenfelter 14% Overdrive Harmonic Balancer
Supercharger Pulley
Belt Description
Part number/ belt / idler
2.60 diameter
2160 mm 11 rib belt
11PK2160 / 90 mm
2.35 diameter
Stock belt
76 mm idler L250120309
Factory belt specs
2137 mm 11 rib belt
12627521 / 90 mm idler
Pulley diameters are measured with a 2.5 mm check ball. If measuring the pulley diameter directly with a caliper the diameters will be closer to 2.60" and 2.35". The 2.38"? pulley when combined with our 14% overdrive damper will result in a supercharger speed 23,000 RPM at 6,500 RPM engine speed. Based on LPE testing we do not recommend exceeding 23,000 RPM on the LS9 supercharger.
Modifications listed on this page will requires recalibration of the factory ECM.
Please call for availability of this item as it may be on Backorder from Manufacturer.
|