C6 Corvette Corner Mount NVX Speaker Enclosure with NVX 10" Sub Woofer for the Drivers and/or Passenger side rear compartment.
This is designed specifically for their NVX NSW104V2Sub Woofer Speaker. With adequate space and volume for this large driver.
Factory top still mounts in place!! Custom molded fiberglass box covered in Ebony Style carpeting that matches the C6 carpeting in color, and is very close in texture.
We try to maintain an inventory in stock, Please allow 1 week for building time due to high demand. Thanks!!
Custom Stamped Steel Basket Our custom basket offers several distinct advantages over traditional designs. We purposefully chose an especially open basket to improve airflow to reduce compression of the motor structure for both improved cone control as well as reduced back-wave interference. nvx-site-spec-number-graphic-4-082814.jpg 2” High Temperature Aluminum Voice Coil The stout 2" high temperature voice coil is constructed from a copper wire wrapped around an aluminum former. This industry standard design is powerful enough to readily drive the cone with strict linear control, yet at the same time remains efficient enough for the compact, space saving magnet structure. nvx-site-spec-number-graphic-5-082814.jpg High-Energy Ferrite Magnet Motor Structure We chose a highly magnetized single stacked Ferrite magnet for the motor structure in the new N-Series. This magnet allows for greater power handleing and voicecoil control during high excursion limits. Ultra-Light Non-Pressed Paper Cone After testing scores of different cone materials, we decided on a custom blend of fine Ultra-Light Non Pressed Paper fibers. This stiff yet lightweight material produces spectacularly accurate bass with a rich, natural tonal quality prized by audiophiles. The smooth matte finish of the cone offers a sleek, modern accent to the interior of any car. High-Excursion Strain-Relieved Tinsel Leads At NVX we understand that the components of a subwoofer must work in harmony to achieve sonic excellence, and that a subwoofer is only as reliable as its weakest link. There is perhaps no better example of our relentless attention to detail than the unique attachment method of our tinsel leads. Whereas the leads of most subwoofers are simply glued atop the spider, ours are glued at the basin of each fold in the spider with enough slack on top for unrestricted excursion. NVX Embossed Rubber Magnet Boot We didn't even skimp on the magent boot for our N-Series subwoofer. Beside looking better than a bare magnet the rubber boot protects the magnet from chipping and possible corrosion that can affect magnets exposed to the elements.
General Features: 10" Dual 4-Ohm N-Series Version 2 Subwoofer Power Handling: RMS: 200-350 watts Ultra-Light Non Pressed Paper Cone Custom Blended Foam Surround 2” High Temperature Aluminum Voice Coil Single 40 oz. magnet motor structure with protective rubber boot Nomex single spider Stamped steel basket for maximum rigidity Top-mount depth: 4.20" Frequency Response: 20 - 200Hz Resonance Frequency (Fs): 36.40 Hz Sensitivity: 89 dB |